When it comes to classic cars, the 1965 Chevy C10 is a popular choice among enthusiasts. One of the important components of this classic truck is the tail light wiring. If you’re looking for a wiring diagram for your 1965 Chevy C10 tail lights, then you’ve come to the right place. In this article, we’ll walk you through the steps of wiring your tail lights, and provide you with a comprehensive wiring diagram.
What You’ll Need
Before we get started, let’s take a look at the tools and equipment you’ll need:
- Screwdriver
- Wire cutter/stripper
- Electrical tape
- Wiring diagram, which we’ll provide below
Wiring Diagram
Below is the wiring diagram for your 1965 Chevy C10 tail lights. This diagram shows all the wires and connections that you will need to make to get your tail lights working properly.
| Wire Color | Function | Location |
| Black | Tail Light Ground | Body |
| Brown | Left Turn Signal | Left Rear |
| Yellow | Left Brake Light | Left Rear |
| Green | Right Turn Signal | Right Rear |
| Dark Green | Right Brake Light | Right Rear |
| Light Blue | Reverse Light | Body |
Step-by-Step Guide
Follow these steps to wire your 1965 Chevy C10 tail lights:
Step 1: Disconnect the Battery
Before beginning any electrical work, it’s important to disconnect the battery to avoid any electrical shocks or short circuits.
Step 2: Remove the Tail Lights
Using a screwdriver, remove the screws holding the tail lights in place, and carefully remove the tail lights from the truck.
Step 3: Identify the Wires
Identify the wires that need to be connected to the tail lights. Refer to the wiring diagram above to ensure that you have the correct wires.
Step 4: Strip the Wires
Using a wire stripper, carefully strip the insulation off the ends of the wires that will be connected to the tail lights.
Step 5: Connect the Wires
Using the wiring diagram above as a guide, connect the wires to the tail lights. Use electrical tape to secure the connections and prevent any moisture from getting into the wiring.
Step 6: Test the Lights
Reconnect the battery and test the tail lights to ensure they are functioning properly.
FAQs
What happens if I connect the wires incorrectly?
If you connect the wires incorrectly, you could cause a short circuit or damage your tail lights. Always refer to the wiring diagram and make sure you have correctly identified the wires before making any connections.
What size wire should I use?
The wire size you should use will vary depending on the amount of electrical load you plan to put on the circuit. In most cases, 16-gauge wire should be sufficient for tail light wiring.
Can I use crimp connectors instead of electrical tape?
Yes, you can use crimp connectors instead of electrical tape. Just make sure the connectors are properly sized for the wires you are using and that they are crimped securely.
Can I install LED tail lights on my 1965 Chevy C10?
Yes, you can install LED tail lights on your 1965 Chevy C10. However, you will need to make sure the wiring is compatible with the LED lights, as they may have different wiring requirements than traditional incandescent bulbs.
Do I need any special tools to install my tail lights?
No, you don’t need any special tools to install your tail lights. A screwdriver, wire stripper, and electrical tape should be all you need for this job.
How long should it take to wire my tail lights?
The time it takes to wire your tail lights will depend on your level of experience with electrical work. For someone with experience, it should take no more than an hour to complete this job.
We hope this article has been helpful in wiring your 1965 Chevy C10 tail lights. If you have any further questions, feel free to leave a comment below. Happy wiring!
